See SIGNALWARE's Home Page or Customer Reply Form for further assistance.

Signalware daughterboards are electrically compatible with boards supporting a TI Common Connector Daughterboard Interface. The DSP Development boards listed below have TI Common Connector Interfaces. The only issues of compatibility are:

1. Mechanical fit of the daughterboard with the development board. (MF)
2. Availability of software to demonstrate the daughterboard operation. (SW)
3. Daughterboard sampling rate and the ability of the DSP to handle the data. (SR)
4. Availability of hardware either daughterboard or development board. (HW)

In the table below, these compatibility issues are addressed for each possible configurations as follows:

OK - all issues with the use of the configuration have been addressed

Adaptor- configuration requires an adaptor (ORS90x supplied by Signalware)

HW - development board hardware issue(s) and/or availability of hardware

MF - mechanical fit issue (resolved by a mechanical adaptation of daughterboard)

SA - special adaptation, special software and FPGA configuration required (extra cost)

SR - sampling rate restriction to less than the full daughterboard capability due to DSP limitation

SW - availability of software

* - issue addresed in supplementary document (click on item for more information)

# - combination not tested, target board may have to be supplied for testing

(date) - solution is expected to be available by that date

? - date of availability unknown

NA - not available in this combination

For information on the Signalware daughterboards in the table above, click the column title or see our Summary of Signalware Daughboards. For software and FPGA configurations for these combinations, see software compatibility table

See SIGNALWARE's Home Page or Customer Reply Form for further assistance.